PurgeX®™️

G5FS is Australasia’s Major Manufacturer and Supplier of Purging Material

PurgeX^®™Used to Assist in the Cleaning up of Plastics Processing Equipment.

PurgeX^®™ has been Used Successfully by Australian and International Polymer Processors for Many Years.

PurgeX^®™ is Registered Trade Mark for a Range of Purging Compounds.

These Satisfied Customers Attest to the Benefits of Using PurgeX^®™in their Process.

PurgeX®™️ T, S and R grades

PurgeX®™️ A (acrylic) grade

PurgeX^®™ Grades

PurgeX^®™ T For Injection Moulding (except where openings are less than 1.5mm)
PurgeX^®™ S For Extrusion, Blow Moulding, and Injection Moulding with Openings Less than 1.5mm
PurgeX^®™ R For Hot Runner Systems with a Minimum Clearance of 0.75mm
PurgeX^®™ A For Injection Moulding and Extrusion

How PurgeX^®™Works

PurgeX^®™ is a granular material that is blended in with a small amount of the polymer that you are using and fed into a starved screw/barrel.

The blended material is processed through your equipment at similar temperatures and revs to typical run conditions for the carrier polymer.

The PurgeX^®™ material softens slightly, but does not melt, and thoroughly loosens carbonized and degraded resin, allowing the polymer to flush out the system.